Push the inflator needle into the ball's valve hole, then re-inflate the ball gently by using a hand pump. Fill the ball to its recommended pressure setting and do not over-inflate. Valve Leak. Insert a wet inflating needle into the valve hole several times to clean dirt from the valve. Insert a toothpick into the valve hole if the leak persists.
To inflate a basketball, all you'll need is an air pump and a ball needle. First, attach the ball needle to the pump, and moisten it with some water. Then, stick the needle into the hole in the ball, which will look like a little black circle. Once the needle is inserted, start pumping your ball. Remove the needle when the ball is inflated.
More Basketball Pump Hole images
Once that is done, get a paper clip and straighten it out. Place it into the air hole. Then, put the tube over the paper clip and push it into the ball. You can then pull out the paper clip from the other side. You now have a straw that leads directly into the ball. You can inflate the basketball by blowing into it for a few minutes until it is full.
How to Fix/Repair Punctured Basketball [Easiest Way Ever!!!] Watch Latest: https://youtu.be/WTjaedGUm6w MATERIA...
Solution 1: if the leak is emanating from the surface, there is a small puncture in the bladder or surface, causing the leak. Now, inflate the ball until it is 70-80% full. Buy a ball repair sealant RL420 and shake it well. Then wet the sealant can’s insertion needle with water and push it all the way into the valve.
See more videos for Basketball Pump Hole
Insert the needle into the hole. Screw the needle in until it is firmly attached. Be careful, as you may accidentally puncture the basketball if too much force is used in the wrong place. Young children should ask an adult for help to avoid injury from needles or an exploding ball.
What happens when you get a ball but do not have a ball pump to inflate it with? I have heard you can inflate a ball using the power of your lungs so, i put ...
Straighten the paper clip and insert it into the air hole of the ball. Cut around the end that's sticking out and then pull the metal out, leaving the plastic "tube" mostly inside the ball. You will be placing your writing-cap "needle" (which you've now attached to an air pump) into this plastic casing. It will look like this: